Flight Attendant’s “Auto Mode” is designed to maximize rider efficiency. In Auto Mode, Flight Attendant adapts as you go, adjusting the fork and rear shock between Open, Pedal, and Lock positions. ...
See more
With the combination of sensors and the Flight Attendant algorithm, we feel there is much more to Flight Attendant than speed alone. However, if we are looking at raw data, the system analyzes terr...
See more
Yes, Flight Attendant only works with SRAM/Quarq power meters. Both spindle- and spider-based power meter styles will work with Flight Attendant, including Quarq 8-bolt power meters.
See more
ANT+ and/or BLE bike computers are compatible with the SRAM spindle- and spider-based power meters that are recommended for Flight Attendant systems. Check with the computer manufacturer to ensure ...
See more
First, you will need to make sure your firmware is up to date, depending on what damper you have:
• Charger Race Day 2 Flight Attendant: Version 2.44.6 or later• Charger 2.1 Flight Attendant: 2.44....
See more
The Pedal Sensor or power meter is a crucial part of the Flight Attendant system, as it gathers data from the rider to make smarter and more predictive, personalized decisions. Note: Adaptive Ride ...
See more
Adaptive Ride Dynamics cannot work without an SRAM/Quarq power meter. With a compatible bike computer, the power meter also provides the opportunity to measure your effort during a ride and record ...
See more
To begin pairing RockShox Flight Attendant, use the Quick Start Video or read the pairing summary below.
IMPORTANT: When using RockShox Flight Attendant in combination with an AXS drivetrain or dro...
See more
Set up is simple. Pair your AXS components (including Flight Attendant as a part of the AXS Ecosystem), set up your suspension by setting your air pressure and rebound for both the fork and rear sh...
See more
The Flight Attendant system consists of fork and shock modules, as well as a pedal sensor, individual dampers are not available for purchase. However; complete Flight Attendant aftermarket upgrade ...
See more
No. However, the RockShox TrailHead App can be used for initial suspension settings, or check out the RockShox Suspension Setup and Tuning Guide on the SRAM Service Site. Flight Attendant in Auto M...
See more
The Super Deluxe Ultimate Flight Attendant rear shock uses more space than non-Flight Attendant Super Deluxe. The fork offerings and crank sets are a consistent size with non-Flight Attendant count...
See more
The pedal sensor is designed to work with our XX1 and X01 DUB spindles, but is compatible with most DUB spindles except the DUB 83 (DH) spindles and "V2" X0 T-Type crankset.
See more
Control Module LEDs:Green LEDs indicate you are in AUTO Mode.Orange LEDs indicate you are in Override Mode.Red LEDs indicate you are in Manual Mode.Yellow LEDs indicate you are in Safe Mode.Magenta...
See more
Rebound is manually adjusted using the rebound adjuster knob found on the rear shock and on the bottom of the fork’s lower leg. This can be adjusted any time by the rider.
Low Speed Compression can...
See more
Yes! In Auto Mode, no additional controller is needed. While in Manual Mode, you can either use the Control Module “+” or “–“ buttons, or the new left hand, 2-position AXS controller to cycle throu...
See more