PROBLEM
If one or more red LEDs on the Fork Controls Module are pulsing during calibration, the system has detected too much lean for a successful calibration.
POSSIBLE CAUSES
The bicycle is leaning too far in the direction of the red LED(s).
TROUBLESHOOTING
Slowly tilt the bicycle toward the pulsing white LED until the red LED(s) are no longer illuminated. Hold the bike steady in this position until the pulsing white LED flashes rapidly.
OUTCOMES
1. The system calibrates successfully and enters Auto Mode (green pulsing LED). All is well, go ride!
2. The system cannot be placed into Calibration Mode. Reach out to your point of purchase for assistance.